Vans Aircraft RV-12 Airplane Build, Section 31A: Wing Electrical Interconnector Update (part 6) & Section 40: Lighting Kit

Reference: Pages 40-09 (now page 40-10), 31A-06; 3.0 hours

Today I am going back to working on the wing tip lighting and wiring for the RV-12 airplane.

Step 8: Crimp male Molex pins on the ends of all the wires coming from the LN-200 Wing Tip Nav/Position/Strobe Light -Red & -Green.



Step 9: Snap the male Molex pin on the end of the black wire coming from the LN-200 Wing Tip Nav/Position/Strobe Light -Red & -Green into a female Molex connector housing opposite the position of the WH-B211 (WHT) Nav/Strobe Ground Wire.



Step 10: Snap the male Molex pin on the end of the red wire coming from the LN-200 Wing Tip Nav/Position/Strobe Light -Red & -Green into the female Molex connector housing opposite the position of the WH-B212 (WHT) Nav Power Wire.

Step 11: Snap the male Molex pin on the end of the yellow wire coming from the LN-200 Wing Tip Nav/Position/Strobe Light -Red & -Green into the female Molex connector housing opposite the position of the WH-B203 (WHT) Strobe Power Wire.



Step 12: Snap the male Molex pin on the end of the green wire coming from the LN-200 Wing Tip Nav/Position/Strobe Light -Red & -Green into the female Molex connector housing opposite the position of the WH-B318 (WHT) Strobe Synch Wire.



Step 13: Label the Molex connector housings as to which wire goes in what position.

Tomorrow I will pick up where I left off today.